For example, if the IP address on your main router is 192.168.30.1, assign 192.168.30.2 to the second router. Afterward, you need to change the IP address of the second router to any free address. ![]() You also need to disable the DHCP Server because your main router assigns IP addresses to the connected devices.Some routers might have the mode labeled as NAT, and you have to disable it in that case. Navigate to Advanced Routing under Setup and switch to Router Mode.The SSID can be different so it’s easier for you to distinguish between the two routers. These include the channel, the Wireless mode, and the security mode. Once inside Settings, change all the values to match your main router.D-Link and Netgear routers have 192.168.0.1 as the default IP address. Launch your browser and type 192.168.1.1, which is usually the default IP address. ![]() Of course, the router needs to be turned on. ![]() Reset the second router to factory settings and connect it to the main router via Ethernet cable.At this point, you can proceed to configure the second router. Make sure to note your passwords and security mode (WPA2, WPA, or WEP). Select Wireless Settings and write down the channel, Wireless mode, and the SSID.
0 Comments
Leave a Reply. |